Flush bolts are used most often on french doors.
French door flush bolt stuck.
In other words the hinges are on the outside and the doors close together in the middle.
My french door is stuck.
The inactive door is held closed with a flush bolt at the top and bottom.
Drill a series of holes to remove most of the timber before chopping out the rest of the shape.
Push or pull on the door without pulling the barrel bolt lever or pulling on the small chain.
One is a knob that you turn and opens the deadbolt directly above the handle.
Flush bolts are recessed into the door edge top and bottom and slide upward or downward into the jamb or threshold to keep the door closed.
Disassemble the door knob that contains the lock on the french doors using a screwdriver to loosen and remove the bolts so that each half falls away from each other.
This was a set of outswing patio french doors aluminum clad jeld wen 3 point mortise lock with the shoot bolts top and bottom stuck in locked position.
The internet will tell you to expose the side of mortise lock behind the trim multitool or drill chisel etc.
Why is my french door latch stuck.
And look for a sliding mechanism.
The latch is a small but vital component of any french door.
If the door opens easily it may be because the spring loaded bolt is stuck in the down position.
A flushbolt is commonly used on commercial residential patio doors and especially french doors.
The locking hardware is two steps.
At such time the inactive door can be fit with the flush bolts to keep it secure.
If your latch keeps getting stuck it could make your doors unusable over time.
It has a lever type handle and it will not budge up or down.
The key here is deciphering if the problem is with the latch itself or with the door.
Step 2 spray the inside mechanics of the french door knob thoroughly using canned air duster to dislodge any dust or other large buildup.
I have taken off all the hardware inside and out and still cannot get to the problem.
Importantly you can see the pivoting rod inside the bolt is at an angle and more needs to be removed from the deepest part than where the flush bolt will actually be screwed into the top edge of the door.
Generally when you have a set of double doors one of the doors is inactive the majority of the time and the other door closes into it.
