Grip the head of the metal screw with.
Getting dents out of aluminum siding.
Screw the 6 self tapping screw into the center of the dent.
Drill a small hole into the middle of the dented area of the aluminum siding.
You want it where it s deepest.
Drill a couple of 1 8 inch holes in the part of the siding that contains the dent.
Don t use just any braising rod.
David kirkham 317 053 views.
Hammer off dolly for stress relieving is the best technique to avoid stretching aluminum.
Work slowly and stop the drill before.
How to fix small dents in aluminum siding drill a hole in it insert a sheet metal screw tug the washer putty the hole sand the spot prime and paint the repair.
Sanding sponges work.
Put on safety goggles.
Wipe down the aluminum trailer s dent to get it moist.
Dampen a rag in water.
One drills a hole through the very center of the dent and inserts the hook at the end of the suction device which typically looks like a plunger.
It doesn t take a lot.
Slapping spoons and other techniques are also good ways to relieve stress and not damage the metal.
How to repair a dent in an enclosed aluminum trailer step 1.
Kirkham university aluminum fender dent repair duration.
Place a flat washer onto a sheet metal screw and then screw it part of the way into one of the holes you drilled.
Here s what to do.
Do not weld on aluminum unless you have had proper aluminum welding training.
Place a plunger against the dent and push down to create suction.
Hammering will leave hammer marks but if your really good at it you might be able to hammer it out and have it look decent.
Braising is totally different and anyone can do it with the proper aluminum braising rods.
Specially designed suction devices are sold in car repair stores for this purpose.
Next pull on the screw with a pair of pliers.
Using boiling water to get car dents out duration.
Use caution if you are standing on a ladder.
Hopefully the dent will pop out and the siding will be.
Very large dents can be fixed by actually pulling the dent into line with the rest of the sheet metal.
Play pause space step 2.
Push a metal screw into the hole far enough so that it becomes difficult to turn.
Pull back on the plunger to straighten the dent.
